Hi, I am using a custom board having DM6467. The board has an IR reciever on GPIO (at base address 0x01C67000). I want to make an application that read the data corresponding to the key pressed on the IR transmitter. Right now, I am continuously reading "OUT_DATA2" register(at offfset 48h from base address 0x01C67000) which gives the current state of the GPIO signal. But this register gets overwritten and hence I can not get the correct value when perticular key is pressed.
So can any one guide me to read the correct value of the GPIO pin (corresponding to IR) when a key is pressed on IR transmitter? THANK YOU DHAVAL LAKKAD eInfochips -- _____________________________________________________________________ Disclaimer: This e-mail message and all attachments transmitted with it are intended solely for the use of the addressee and may contain legally privileged and confidential information. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, copying, or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately by replying to this message and please delete it from your computer. Any views expressed in this message are those of the individual sender unless otherwise stated.Company has taken enough precautions to prevent the spread of viruses. However the company accepts no liability for any damage caused by any virus transmitted by this email. __________________________________________________________________________ _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
