Hi,
Is the mass storage device High Speed or Full speed? It seems to
get enumerated as a Full speed device. Is this issue seen with any USB MSC
device?
Regards
swami
________________________________
From: davinci-linux-open-source-bounces+swami.iyer=ti....@linux.davincidsp.com
[mailto:davinci-linux-open-source-bounces+swami.iyer=ti....@linux.davincidsp.com]
On Behalf Of kirthika varadarajan
Sent: Tuesday, September 15, 2009 3:16 PM
To: [email protected];
[email protected]
Subject: USB Master and Slave in DM6446
Dear All,
I am working with DM6446.I need to check USB Mass Storage Device and USB
Function Controllers.
Whenever i plug in Mass Storage Device I am getting the below said debug
messages and finally my USB device is not recognized.
usb 1-1: new full speed USB device using musb_hdrc and a
ddress 4
usb 1-1: khubd timed out on ep0in
usb 1-1: device descriptor read/64, error -110
usb 1-1: device descriptor read/64, error -19
usb 1-1: new full speed USB device using musb_hdrc and address 5
usb 1-1: khubd timed out on ep0in
usb 1-1: device descriptor read/64, error -110
usb 1-1: device descriptor read/64, error -19
When i connect from DM6446 to PC again its not even detection in DM6446.
Is there any way to figure out and solve the USB issue in DM6446
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
