On Thu, Nov 11, 2010 at 23:48:55, Sergei Shtylyov wrote: > Hello. > > Savinay Dharmappa wrote: > > > From: David Griego <[email protected]> > > > OMAP-L137/AM17x has limited number of dedicated EMIFA > > address pins, enough to interface directly to an SDRAM. > > If a device such as an asynchronous flash needs to be > > attached to the EMIFA, then either GPIO pins or a chip > > select may be used to control the flash device's upper > > address lines. > > > > This patch adds support for the NOR flash on the OMAP-L137/ > > AM17x user interface daughter board using the latch-addr-flash > > MTD mapping driver which allows flashes to be partially > > physically addressed. The upper address lines are set by > > a board specific code which is a separate patch. > > > Signed-off-by: David Griego <[email protected]> > > It's again not clear why you've dropped my and Alexei's signoff. Did we > request you to do so?
I had sent this series to all MV folks to get their signoff but nobody replied. If you are OK with the updated version of this patch, which I'll be submitting shortly, please add your signoff. Regards, Savinay. _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
