Hello.
On 12-11-2010 7:20, Savinay Dharmappa wrote:
OMAP-L137/AM17x has limited number of dedicated EMIFA
address pins, enough to interface directly to an SDRAM.
If a device such as an asynchronous flash needs to be
attached to the EMIFA, then either GPIO pins or a chip
select may be used to control the flash device's upper
address lines.
This patch adds support for the NOR flash on the OMAP-L137/
AM17x user interface daughter board using the latch-addr-flash
MTD mapping driver which allows flashes to be partially
physically addressed. The upper address lines are set by
a board specific code which is a separate patch.
Signed-off-by: David Griego<[email protected]>
It's again not clear why you've dropped my and Alexei's signoff. Did
we
request you to do so?
I had sent this series to all MV folks to get their signoff but nobody
replied.
Why get our signoffs again if they were on the original patches that you
used?
If you are OK with the updated version of this patch, which I'll be
submitting
shortly, please add your signoff.
Well, OK...
Regards,
Savinay.
WBR, Sergei
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
