I haven´t a authentication problem. My network is completely open. No Wep, no wpa, ... nothing :(
You see this ... wlan1: Initial auth_alg=0 wlan1: authenticate with AP 00:17:9a:f3:f6:03 wlan1: RX authentication from 00:17:9a:f3:f6:03 (alg=0 transaction=2 status=0) wlan1: authenticated wlan1: associate with AP 00:17:9a:f3:f6:03 wlan1: associate with AP 00:17:9a:f3:f6:03 wlan1: associate with AP 00:17:9a:f3:f6:03 wlan1: association with AP 00:17:9a:f3:f6:03 timed out I saw with the utility modconf the modules available and there are several cards that would have to be "plug and play". with the kernel 2.6.18-4-ixp4xx Some of those is sold at the moment? Thanks p.d: [EMAIL PROTECTED] Can you speak spanish? :) El lun, 30-04-2007 a las 10:59 +0200, Xan escribió: > En/na Joakkinen ha escrit: > > Hi, > > > > I have a NSLU2 and I want to connect it to my wireless network. I have > > several wireless cards based on the chip rt2570 or rt73. I compiled the > > modules rt2570, and rt2x00 with module-assistant and put the firmware in > > the directory /lib/firmware and the card seems that it works. I can > > detect my access point (iwlist scan) but I can`t associated with it. > > dmesg say this ... > > Hi Joakkinen, > > I'm not a developer. I'm just a desktop user. > I have too a rt2570 usb wifi and I'm planed to install it. I know that > it's could be done with modules but I did not see the rt2x00 > documentation yet. > > Can you pointing me what do you dit exactly for install it? I will thank > you very much > > > In reference to your question: if card seems that it works you have > _only_ an authentication problem. I think it's a simple problem. > > Do you use any authentication method in access point: wep, wpa, ? > What device is your wifi: ra0, eth1, ...? > > Perhaps I could help you (but I don't promise it ;-)) > > Regards, > Xan > > > > > > wlan1: authentication with AP [ap mac] timed out > > > > Now I am following these instructions ... > > > > http://www.nslu2-linux.org/wiki/Peripherals/WirelessNetworkAdapter > > (section rt73) > > > > ... but they seem complicated. > > > > Another question. > > > > Exists ndiswrapper for arm arquitecture? > > > > Thanks. > > > > > > > > > > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
