Hi, Dom, 2011-01-09 às 18:21 +0100, Tomten Larsson escreveu: > Package: installation-reports > > Boot method: <How did you boot the installer? CD > Image version: <Full URL to image you downloaded is best> > http://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-CD-1.iso > Date: <Date and time of the install> 2011-01-09 > > Machine: <Description of machine (eg, IBM Thinkpad R32)> Sun Sparc Ultra 10 > Processor: Ultra SPARC IIi 333 MHZ > Memory: 1GB > Partitions: <df -Tl will do; the raw partition table is preferred> ? didn't > go that far > > Output of lspci -knn (or lspci -nn): didn't go that far > > Base System Installation Checklist: E > [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it > > Initial boot: [ ] > Detect network card: [ ] > Configure network: [ ] > Detect CD: [ ] > Load installer modules: [ ] > Detect hard drives: [ ] > Partition hard drives: [ ] > Install base system: [ ] > Clock/timezone setup: [ ] > > > User/password setup: [ ] > Install tasks: [ ] > Install boot loader: [ ] > Overall install: [ ] > > Comments/Problems: > > <Description of the install, in prose, and any thoughts, comments > and ideas you had during the initial install.> > start to boot and prints lots of messages on screen, but then stops > the last messages are > [0.000000] Booting Linux... > [0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total > pages: 130071 > [0.000000] Kernel command line: > [0.000000] PID hash table entries: 4096 (order: 12, 32768 bytes) > [0.000000] clocksource: mult[300c5] shift[16] > [0.000000] clockevent: mult[553f7ced] shift[32] > [42.966816] Console: colour dummy device 80x25 > [43.020133] console handover: boot [earlyprom0] -> real [tty0] > after this nothing seems to happen > > I have previously been running Sarge and FreeBSD 8.1 so the hardware should > be fine. > rescue mode has the same problem, expert mode has the same problem > > The following image has a similar problem, the error message is a bit > different, but stops when doing something with the console > http://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-businesscard.iso > last line is: > [0.000000] console [tty0] enabled, bootconsole disabled
The latest debian installer release it's Squeeze Beta 2 (and RC1 is about to be released [2]), can you try and report against this version? 1 - http://www.debian.org/devel/debian-installer/index.en.html 2 - http://cdimage.debian.org/cdimage/.squeeze_di_rc1/ -- Melhores cumprimentos/Best regards, Miguel Figueiredo http://www.DebianPT.org -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: http://lists.debian.org/[email protected]
