Package: install Version: latest Severity: important Tags: woody Hi
I just installed woody on my laptop and was surprised that it autodetected my pcmcia card just fine. That is the good news. The bad news is that when I rebooted my computer it did not have dhcp (which I used in the beginning) installed on the computer, and the pcmcia init script was not runned at boot-time. So I had to configure the network manually using route and ifconfig. Then I runned tasksel with X and laptop and everything installed just fine. So two things is needed. *1* The dhcp package should be downloaded and installed in the first install run and the configuration should be stored from the initial net configuration. *2* If I have configured pcmcia it should be runned while booting. There was also some error messages when running, so it should probably be updated from the version in woody. I'm not sure how this works, but a updated version was installed later when tasksel was running. Thanks for a new improved installation system. :) Best regards, // Ola PS. I used a 3com pcmcia network card when installing. DS. -- --------------------- Ola Lundqvist --------------------------- / [EMAIL PROTECTED] Bj�rnk�rrsgatan 5 A.11 \ | [EMAIL PROTECTED] 584 36 LINK�PING | | +46 (0)13-17 69 83 +46 (0)70-332 1551 | | http://www.opal.dhs.org UIN/icq: 4912500 | \ gpg/f.p.: 7090 A92B 18FE 7994 0C36 4FE4 18A1 B1CF 0FE5 3DD9 / --------------------------------------------------------------- -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
