Package: installation-reports
Boot method: USB
Image version:
ftp://ftp.ch.debian.org/debian/dists/testing/main/installer-armel/current/images/kirkwood/network-console/lacie/
Date: October 26, 2014, 10:00 CET
Machine: LaCie 2Big Network 2
Processor: Feroceon 88FR131 rev 1 (v5l)
Memory: 256 MB
Partitions: <df -Tl will do; the raw partition table is preferred>
~ # df
Filesystem 1K-blocks Used Available Use% Mounted on
none 25376 64 25312 0% /run
devtmpfs 121720 0 121720 0% /dev
Output of lspci -knn (or lspci -nn):
~ # lspci -knn
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [ ]
Load installer modules: [E]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [E]
Comments/Problems:
After I chose the mirror (whatever the mirror), the installer complains that it
cannot find kernel modules in the archive. It gives the following message:
No kernel modules were found. This probably is due to a mismatch between the
kernel used by this version of the installer and the kernel version available
in the archive.
If you're installing from a mirror, you can work around this problem by
choosing to install a different version of Debian. The install will probably
fail to work if you continue without kernel modules.
Continue the install without loading kernel modules?
<Go Back>
<Yes> <No>
I need the RAID modules which are not included in the ramdisk, so the install
does not work for me.
Note that it worked last week. The archive seems to have been updated yesterday
but the kernel images were built on October 2. I guess the images just need to
be rebuilt against the current archive.
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive:
https://lists.debian.org/[email protected]
