I have to go to work in a few minutes, but I just wanted to pass on a couple things I found in a powerpc install attempt yesterday.
* In the partitioner display, there is no column for the names of the partitions. Or maybe the issue is that for powerpc, the names are not detected properly. Column headings would be very nice too. * Also in the partitioner, when I selected partition 10 or 11 to apply a filesystem or swap, the changes were made in the displayed table to partition 1 instead. If those changes were actually applied to partition 1 on a powerpc, it would wipe out the partition table and then you would lose everything on the disk!!! * When switching to console 2, then back to console 1, the display is not refreshed in console 1. So it looks like you haven't switched and can't get back. If you start hitting Tab, buttons show up over the console 2 text. * Maybe related: when I tried the Execute a Shell menu item, the text overwrote the existing screen, and CR's were not displayed so lines came out in a warerfall. * After installation of extra packages completes, the next item offered is Automatic partitioning! I guess it is because of the dependency map, probably there should be nothing depending on automatic partitioning. -- Debian GNU/Linux Operating System By the People, For the People Chris Tillman (a people instance) toff one at cox dot net -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
