Package: installation-reports Debian-installer-version: <11 May 2004, Beta version for Sparc from Debian Website, the "110 Mb version"> uname -a: <None (Kernel panic happened before that)> Date: <11 May 2004, around 18h CET> Method: <Boot off CD-Rom, I/O on terminal through serial port>
Machine: <Sparc Ultra 30> Processor: Ultrasparc II 300 MHz Memory: 256 Mb Root Device: <Theoretically a SCSI drive, /sca> Root Size/partition table: <Kernel paniced before this stage> Output of lspci: N/A Base System Installation Checklist: Initial boot worked: [E ] Configure network HW: [ O] Config network: [ ] Detect CD: [ O] Load installer modules: [ ] Detect hard drives: [ O] Partition hard drives: [ ] Create file systems: [ ] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [ ] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: Kernel panic shortly after launching install, see screen print-out. [ ENTER - Boot install ] [ Type "rescue" - Boot into rescue mode ] boot: Allocated 8 Megs of memory at 0x40000000 for kernel Loaded kernel version 2.4.24 Loading initial ramdisk (1808523 bytes at 0x40C00000)... \ Remapping the kernel... done. Booting Linux... PROMLIB: Sun IEEE Boot Prom 3.9.5 1997/04/11 10:03 Linux version 2.4.24-sparc64 ([EMAIL PROTECTED]) (gcc version 3.3.3 20040125 (prerel4 ARCH: SUN4U Ethernet address: 08:00:20:9b:dd:f3 initrd extends beyond end of memory (0x00000000c0db988b > 0x000000006ff28000) disabling initrd On node 0 totalpages: 32142 zone(0): 32660 pages. zone(1): 0 pages. zone(2): 0 pages. Found CPU 0 (node=f0072258,mid=0) Found 1 CPU prom device tree node(s). Kernel command line: root=/dev/rd/0 cdrom devfs=mount rw Calibrating delay loop... 591.46 BogoMIPS Memory: 254016k available (2504k kernel code, 584k data, 184k init) [fffff80000] Dentry cache hash table entries: 32768 (order: 6, 524288 bytes) Inode cache hash table entries: 16384 (order: 5, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 8192 bytes) Buffer cache hash table entries: 8192 (order: 3, 65536 bytes) Page-cache hash table entries: 32768 (order: 5, 262144 bytes) POSIX conformance testing by UNIFIX PCI: Probing for controllers. PCI: Found PSYCHO, control regs at 000001fe00000000 PSYCHO: Shared PCI config space at 000001fe01000000 PCI0(PBMB): Bus running at 33MHz PCI0(PBMA): Bus running at 66MHz ebus0: [auxio] [power] [SUNW,pll] [sc] [se] [su] [su] [ecpp] [fdthree] [eeprom]] PCIO serial driver version 1.54 su(mouse) at 0x1fff13062f8 (irq = 4,7ea) is a 16550A Sun Mouse-Systems mouse driver version 1.00 su(kbd) at 0x1fff13083f8 (irq = 9,7e9) is a 16550A keyboard: not present SAB82532 serial driver version 1.65 ttyS00 at 0x1fff1400000 (irq = 12,7eb) is a SAB82532 V3.2 ttyS01 at 0x1fff1400040 (irq = 12,7eb) is a SAB82532 V3.2 Console: ttyS0 (SAB82532) power: Control reg at 000001fff1724000 ... not using powerd. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd Journalled Block Device driver loaded devfs: v1.12c (20020818) Richard Gooch ([EMAIL PROTECTED]) devfs: boot_options: 0x1 pty: 256 Unix98 ptys configured rtc_init: no PC rtc found RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) sunhme.c:v2.01 26/Mar/2002 David S. Miller ([EMAIL PROTECTED]) eth0: HAPPY MEAL (PCI/CheerIO) 10/100BaseT Ethernet 08:00:20:9b:dd:f3 Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx SCSI subsystem driver Revision: 1.00 sym.0.3.0: setting PCI_COMMAND_INVALIDATE. sym0: <875> rev 0x3 on pci bus 0 device 3 function 0 irq 4,7e0 sym0: No NVRAM, ID 7, Fast-20, SE, parity checking sym0: SCSI BUS has been reset. scsi0 : sym-2.1.17a sym0:0: FAST-20 WIDE SCSI 40.0 MB/s ST (50.0 ns, offset 15) Vendor: COMPAQ Model: HD0093172C Rev: 3208 Type: Direct-Access ANSI SCSI revision: 02 Vendor: TOSHIBA Model: CD-ROM XM-6201TA Rev: 1037 Type: CD-ROM ANSI SCSI revision: 02 sym0:0:0: tagged command queuing enabled, command queue depth 16. Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 17773500 512-byte hdwr sectors (9100 MB) Partition check: /dev/scsi/host0/bus0/target0/lun0: p1 p2 p3 p4 p5 p6 usb.c: registered new driver usbdevfs usb.c: registered new driver hub host/usb-uhci.c: $Revision: 1.275 $ time 18:40:15 Jan 30 2004 host/usb-uhci.c: High bandwidth mode enabled host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver usb.c: registered new driver usbmouse usbmouse.c: v1.6:USB HID Boot Protocol mouse driver usb.c: registered new driver usbkbd usbkbd.c: :USB HID Boot Protocol keyboard driver mice: PS/2 mouse device common for all mice Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 32768) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. sh-2021: reiserfs_read_super: can not find reiserfs on ramdisk(1,0) Kernel panic: VFS: Unable to mount root fs on 00:00 Press L1-A to return to the boot prom -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
