Package: installation-reports Debian-installer-version: Beta4, 20040601, http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/i386/beta4/sarge-i386-netinst.iso uname -a: Date: 20040602 Method: CDROM linux2.6
Machine: Dell Dimension 8300 Processor: 3.2GHz Memory: 1 gbyte Root Device: SATA Root Size/partition table: N/A Output of lspci: /bin/sh: lspci: not found Base System Installation Checklist: Initial boot worked: [O] Configure network HW: [O] Config network: [O] (not tested as ping not found but looks OK) Detect CD: [O] Load installer modules: [O] Detect hard drives: [E] Partition hard drives: [E] Create file systems: [ ] Mount partitions: [ ] Install base system: [ ] Install boot loader: [ ] Reboot: [O] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Comments/Problems: Issue #1: I chose the linux26 kernel to increase the chances of it detecting my SATA hard disks. After booting, I could not find any evidence that my harddisks were detected (/dev/discs/* only listed my CDROM drive), so I concluded that they weren't detected. When my hard drives weren't detected, I got the partitioning menu regardless, but with no partitions listed. I find this behaviour potentially confusing (especially for new users), it should display an error "no harddisks detected" instead. I thought Linux 2.6 supported SATA, so I am not sure if this is a kernel issue or debian-installer issue. I will continue investigating. I will also try and get correct lspci output. Issue #2: Switching between console screens corrupts screen output when switching back to the first VT. All the writing appears from the previous console instead of the new console with vertical lines to indicate the different colours on the new console. I haven't seen anything quite like it before... I believe the display card is ATI Radeon 9800. For an example, see <URL:http://people.debian.org/~bam/temp/IMG_0327.JPG>, when looking at 4th console and <URL:http://people.debian.org/~bam/temp/IMG_0328.JPG> for after changing back to the 1st console. I haven't been able to get it to correctly redisplay the first console after switching away from it, normal screen redraws don't seem to help. Switching to any other console other then the first one works fine. -- Brian May <[EMAIL PROTECTED]> -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]