TODO
~~~~
* stage 3:
+ Check whether it works properly with hot plugged network
interfaces. That is, stage 3 should not assume that these
interfaces come up at any particular time but should wait
for networking to become available.
* netcfg:
+ Determine whether the primary interface is 16-bit PCMCIA,
cardbus, or neither. Then,
1. If PCMCIA, mark the interface neither "auto" nor "hotplug"[1]
2. If cardbus, mark the interface "hotplug"
3. If neither, mark the interface "auto"
The current code doesn't do this IIUC.
[1] This means, of course, listing the interface name on a "map"
line in the "mapping hotplug" stanza.
--
Thomas
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
