Package: installation-reports
Debian-installer-version: rc1 from installer main page, intel english.
uname -a: Linux (none) 2.4.26-1-386 #2 Sat May 1 16:31:24 EST 2004 i686 unknown
Date: Aug 9, 2004
Method: CD-ROM
Machine: HP ML330 G3 Processor: Xeon, 2.8 Ghz Memory: 256 Root Device: SCSI Root Size/partition table: 10 G on the first disk. Output of lspci:
Base System Installation Checklist:
Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [O] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [E] [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
I have a brand new HP ML330 G3. Two 70 Gig scsi disks. I configured
the / partition on ext3 on the first disk 10 gig. I created a RAID 1
setup on two 60 gig partitions. 250 meg swap on the first disk.
When I rebooted the compure hung. The last interesting message is that the serverworks module can't be loaded because of seg fault. line pci.agent line 156. I was able to setup beta 4 on this computer. Also, I installed with the 2.6 kernel. I don't remember seeing a server works
module being installed in rc4.
The call stack is
kobject_register
bus_add_driver
driver_register
pci_register_driver
ide_pci_register_driver
svwks_ide_init
sys_init_module
syscall_callIt seems to be a 2.6 issue. A reinstall with 2.4 works with with the rc1 installer as well.
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
