Package: installation-reports
Debian-installer-version: 20040802 netboot Date: 2004-09-19 Severity: normal Method: rarp+tftp+http from http.us.debian.org Machine: Sun Netra T105 Processor: TI UltraSparc IIi (Sabre) Memory: 311296k Root Device: Seagate ST39102LC, symbios SCSI Partition Table: Disk /dev/sda (Sun disk label): 12 heads, 214 sectors, 6922 cylinders Units = cylinders of 2568 * 512 bytes Device Flag Start End Blocks Id System /dev/sda1 0 1 1284 83 Linux native /dev/sda2 u 1 409 523872 82 Linux swap /dev/sda3 0 6922 8887848 5 Whole disk /dev/sda4 409 6922 8362692 83 Linux native /dev/sda4 on / type ext3 (rw,errors=remount-ro) proc on /proc type proc (rw) devpts on /dev/pts type devpts (rw,gid=5,mode=620) tmpfs on /dev/shm type tmpfs (rw) usbfs on /proc/bus/usb type usbfs (rw) flurp:~# lspci 0000:00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIi 0000:00:01.0 PCI bridge: Sun Microsystems Computer Corp. Simba Advanced PCI Bridge (rev 13) 0000:00:01.1 PCI bridge: Sun Microsystems Computer Corp. Simba Advanced PCI Bridge (rev 13) 0000:01:01.0 Bridge: Sun Microsystems Computer Corp. EBUS (rev 01) 0000:01:01.1 Ethernet controller: Sun Microsystems Computer Corp. Happy Meal (rev 01) 0000:01:02.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 03) 0000:01:03.1 Ethernet controller: Sun Microsystems Computer Corp. Happy Meal (rev 01) 0000:02:01.0 PCI bridge: Digital Equipment Corporation DECchip 21150 (rev 04) 0000:03:0e.0 IDE interface: Silicon Image, Inc. (formerly CMD Technology Inc) PCI0646 (rev 03) flurp:~# lspci -n 0000:00:00.0 0600: 108e:a000 0000:00:01.0 0604: 108e:5000 (rev 13) 0000:00:01.1 0604: 108e:5000 (rev 13) 0000:01:01.0 0680: 108e:1000 (rev 01) 0000:01:01.1 0200: 108e:1001 (rev 01) 0000:01:02.0 0100: 1000:000f (rev 03) 0000:01:03.1 0200: 108e:1001 (rev 01) 0000:02:01.0 0604: 1011:0022 (rev 04) 0000:03:0e.0 0101: 1095:0646 (rev 03) Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [ ] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [O] Comments: Flawless install, except for one issue -- did the install over a serial console w/ minicom, as usual on Netra hardware. It's all in mono with some boldface highlighting on active options, but after the reboot, the highlighting didn't appear in debconf dialogs, making it hard to navigate. On a subsequent boot I installed and configured ssh over the same console and the highlighting was visible again. -- System Information: Debian Release: 3.1 APT prefers testing APT policy: (500, 'testing') Architecture: sparc (sparc64) Kernel: Linux 2.4.26-sparc64 Locale: LANG=C, LC_CTYPE=C -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
