Package: partman-lvm Version: partman-lvm Severity: normal Tags: d-i I tried the d-i rc1 to install sarge on a Dell 586 64Meg with 2 hd (hd0 - 1G, hd1 -100G).
I installed on the local box until I got to the point where I could create a ssh session. I then started a ssh session to the box under the installer login, was able to create volumes. It appeared that I could create lvols, space was allocated, however it was not accessable. lvdisplay showed the LV Status and unknown. I logged out of the ssh session and went back to the console on the box. The d-i menu was still there. I picked the lvm setup option. deleted the lvols created the lvols (this time it worked) I was able to successfully install sarge from the console. I had a 25M /boot on a primary partition all other files systems (including /) and swap were successfully built on volumes. Not being able to use ssh to setup the lvols was a minor inconvienence. BTW, I was able to do another install over ssh without lvm. jr. -- System Information: Debian Release: 3.1 APT prefers testing APT policy: (650, 'testing'), (600, 'unstable'), (1, 'experimental') Architecture: i386 (i686) Kernel: Linux 2.6.8-1-686-smp Locale: LANG=C, LC_CTYPE=C HTC Disclaimer: The information contained in this message may be privileged and confidential and protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting it from your computer. Thank you. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
