Package: installation-reports INSTALL REPORT
Debian-installer-version: daily build floppy-2.4 power from people.d.o/~luther, as of 29. Sep Method: floppy-2.4, net-driver.floppy, installed unstable Machine: Power Mac 4400/200 Processor: 603ev Memory:48mb Root Device: ide, hda2 0000:00:0b.0 Host bridge: Apple Computer Inc. Bandit PowerPC host bridge (rev 03) 0000:00:0e.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 74) 0000:00:10.0 ff00: Apple Computer Inc. O'Hare I/O (rev 01) 0000:00:11.0 VGA compatible controller: ATI Technologies Inc 264VT [Mach64 VT] (rev 40) processor : 0 cpu : 603ev clock : 200MHz revision : 2.1 (pvr 0007 0201) bogomips : 133.12 machine : Power Macintosh motherboard : AAPL,e826 MacRISC detected as : 47 (Unknown OHare-based) pmac flags : 00000000 L2 cache : 256K unified memory : 48MB pmac-generation : OldWorld Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it Initial boot worked: [O] Configure network HW: [O] Config network: [O] Detect CD: [ ] Load installer modules: [O] Detect hard drives: [O] Partition hard drives: [O] Create file systems: [O] Mount partitions: [O] Install base system: [O] Install boot loader: [O] Reboot: [E] Comments/Problems: The install went fine - the only remaining problem is dealing with quiks quirks with this model (see http://penguinppc.org/bootloaders/quik/quirks.php) I used these commands to make my machine boot. nvsetenv boot-device ata/[EMAIL PROTECTED]:0 nvsetenv boot-file ata/[EMAIL PROTECTED]:0/boot/vmlinux-2.4.27-powerpc nvsetenv input-device kbd nvsetenv output-device screen nvsetenv boot-command boot It should be possible to deal with some of quiks quirks by detecting the machine type based on /proc/cpuinfo (combination of "cpu", "detected as" and possible others should be sufficient - we "only" would need to collect that data..), based on this the nvram could be set to the right values in quiks postinst. regards, Holger -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
