Well, this aint fixed in .21.1 after all. I was just lucky with the IRQ
line being 5:
On Sun, May 13, 2007 at 08:52:32PM +0300, Mikko Rapeli wrote:
> eth0: NE2000 Compatible: io 0x300, irq 5, hw_addr 00:04:E2:B7:6E:5D
> pccard: card ejected from slot 1
> pccard: PCMCIA card inserted into slot 1
> pcmcia: registering new device pcmcia1.0
> eth0: NE2000 Compatible: io 0x300, irq 5, hw_addr 00:04:E2:B7:6E:5D
> pccard: card ejected from slot 1
> pccard: PCMCIA card inserted into slot 1
> pcmcia: registering new device pcmcia1.0
> eth0: NE2000 Compatible: io 0x300, irq 5, hw_addr 00:04:E2:B7:6E:5D
When the card is in place during boot, I always get irq 3 which is also
used by the serial port:
CPU0
0: 74146 XT-PIC timer
1: 759 XT-PIC i8042
2: 0 XT-PIC cascade
3: 27439 XT-PIC pcnet_cs, serial
6: 5 XT-PIC floppy
8: 1 XT-PIC rtc
9: 601 XT-PIC acpi, uhci_hcd:usb1, yenta, yenta, ESS Maestro
12: 106 XT-PIC i8042
14: 5191 XT-PIC ide0
15: 566 XT-PIC ide1
NMI: 0
LOC: 0
ERR: 0
MIS: 0
I got the this same problem with 2.6.8-3 from sarge, .18-4 from etch and
.20.11 and .21.1 from upstream. In single user mode the serial driver is
not used by irattach, so the interrupt line is free:
CPU0
0: 19051 XT-PIC timer
1: 151 XT-PIC i8042
2: 0 XT-PIC cascade
3: 419 XT-PIC pcnet_cs
6: 3 XT-PIC floppy
8: 1 XT-PIC rtc
9: 601 XT-PIC acpi, uhci_hcd:usb1, yenta, yenta, ESS Maestro
12: 106 XT-PIC i8042
14: 1737 XT-PIC ide0
15: 63 XT-PIC ide1
NMI: 0
LOC: 0
ERR: 0
MIS: 0
Perhaps my problems are just hardware/ACPI trouble...
-Mikko
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
