> OK, can you do the following: > - unplug > - replug > - check permissions
Done. crw-rw-r-- 1 root scanner 189, 0 5. Okt 15:40 001 crw-rw-r-- 1 root scanner 189, 6 5. Okt 17:57 007 Correct. Also lsusb shows that Bus 001 Device 007: ID 04b8:0110 Seiko Epson Corp. Perfection 1650 is the new one. > - unplug > - /etc/init.d/udev reload > - plug > - check permissions lsusb: Bus 001 Device 008: ID 04b8:0110 Seiko Epson Corp. Perfection 1650 ls -l /etc/usb/001: crw-rw-r-- 1 root scanner 189, 0 5. Okt 15:40 001 crw-rw-r-- 1 root scanner 189, 7 5. Okt 18:01 008 This seems all to work correct. But XSane does not find the scanner. The problem must be somehere else ? Here again the output as normal user when accessing the scanner via commandline: $> scanimage -L No scanners were identified. If you were expecting something different, check that the scanner is plugged in, turned on and detected by the sane-find-scanner tool (if appropriate). Please read the documentation which came with this software (README, FAQ, manpages). $> sane-find-scanner # sane-find-scanner will now attempt to detect your scanner. If the # result is different from what you expected, first make sure your # scanner is powered up and properly connected to your computer. # No SCSI scanners found. If you expected something different, make sure that # you have loaded a kernel SCSI driver for your SCSI adapter. # Also you need support for SCSI Generic (sg) in your operating system. # If using Linux, try "modprobe sg". found USB scanner (vendor=0x04b8, product=0x0110) at libusb:001:008 # Your USB scanner was (probably) detected. It may or may not be supported by # SANE. Try scanimage -L and read the backend's manpage. # Not checking for parallel port scanners. # Most Scanners connected to the parallel port or other proprietary ports # can't be detected by this program. # You may want to run this program as root to find all devices. Once you # found the scanner devices, be sure to adjust access permissions as # necessary. > > JB. KM -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
