Hi Jonathan, On Sunday 20 May 2007, Jonathan McDowell wrote: > I've been given a HP 9000/D390. It's huge. I've burnt an Etch install > CD (just CD 1 of the official images), but I'm not having a lot of luck > getting it booted with either the 32 or 64 bit kernels. They fail in > different ways and I've attached boot logs of both - a 64 bit boot > fails with a repeating sequence of FLT codes just after "Enumerating > the EISA bus" while a 32 bit kernel prints "Freeing unused kernel > memory: 328k freed" and then just sits there until I press a key at > which point it prints "FLT 0000Kernel panic - not syncing: Kernel > Fault". > > This is all over the serial console - there's no graphics card in the > machine. I've ensured the machine is running the latest firmware (42.10) > as I saw some suggestions that could cause issue, but it makes no > difference compared to the revision that was on the machine beforehand > (38.39). > > Any suggestions appreciated; equally confirmation that I /should/ > expect Etch to run on the D390 would be nice.
do you maybe have ISA/EISA cards in this machine ? If yes, maybe removing them might help ? Regards, Helge -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
