Hi try boot P1 or P0 ;) it only works after sea command. On Sep 1, 2014 4:05 PM, "Jawahar Panchal" <[email protected]> wrote:
> Following-up on the thread - here is the serial console output when I try > and boot from CD (this is the full install cd, not the netinst): > > > 1) Initial SEARCH for boot devices > > Main Menu: Enter command or menu > SEARCH > > Searching for potential boot device(s) > This may take several minutes. > > To discontinue search, press any key (termination may not be immediate). > > > POTENTIAL BOOT DEVICES > > Path# Device Path Device Type > ----- ----------------- ------------------------- > P0 scsiA.6 HP 73.4GST373454LW > P1 ide.0 HL-DT-STDVDRRW GWA-4161B > > > 2) And this is from booting without interacting with the IPL with "boot > ide.0" > > Main Menu: Enter command or menu > boot ide.0 > Interact with IPL (Y, N, or Cancel)?> N > > > Booting... > Boot IO Dependent Code (IODC) revision 1 > > IPL error: bad LIF magic. > .... FAILED. > > > 3) If I interact with the IPL, no difference > > Main Menu: Enter command or menu > boot ide.0 > Interact with IPL (Y, N, or Cancel)?> Y > > Booting... > Boot IO Dependent Code (IODC) revision 1 > > IPL error: bad LIF magic. > .... FAILED. > > > There is no timeout in either case - the error is immediate - so not sure > if that points more to a bad image from the CD-RW. Also, I see that I have > a more recent version of IODC - not sure if this a red herring though. > > I don't have a spare second SCSI drive to copy the image over to - will > see if I can scrounge up something (although at that point TFTP might be > less hassle...) - I only have one drive which will be the install target. =P > > Cheers, > Jay > > > -- > To UNSUBSCRIBE, email to [email protected] > with a subject of "unsubscribe". Trouble? Contact > [email protected] > Archive: > https://lists.debian.org/[email protected] > >
