Re: Booting The Debian GNU/Hurd get locked

[Yuval Tanny]

No. I didn't run it at all. The guide say: "Once you are presented with 
a shell prompt, and any time that the Hurd is in single user mode, it is 
necessary to set the terminal type:". I hadn't presented with a shell 
prompt in the GNU/Hurd system, yet. Should I chroot to in and run it 
(twice?)?

(I'm not using the K8 installer...)
Thanks,
Yuval
Philip Charles wrote:
Yuval,
        Have you run ./native-install twice?
Phil.
On Thu, 20 Jan 2005, Yuval Tanny wrote:
 

Hello,
After following this:
http://www.debian.org/ports/hurd/hurd-install
installation guide, I get this message at boot:
(this is what I see on the screen)
ide0 at 0x1f0-0x1f7, 0x3f6 on irq 14
ide1 at 0x170-0x177, 0x3f6 on irq 15
Floppy...
FDC is a post 1991 82077
Failed initialization of WD-7000 SCSI card!
EATAO, address 0x1f0 in use skipping probe.
EATAO, address 0x170 in use skipping probe.
ppa: Version 1.42
ppa: Probing port 03bc
ppa: Probing port 0378
...(and some other lines from ppa)..
scsi: 0 hosts.
scsi: detected total.
rtl8139.c:B1.23a ...
   http:///www...
eth0: RealTek RTL81396 Fast Ethernet at 0xa00 IRQ 10, 0:e0:ud: 7:98:ca
Now the system lock. It's not responding.
I installed from debian-gnu-hurd-2004.12.30.tar.gz. I have ABIT NF7-S
(nforce 2 with SCSI controller that is in no use) motherboard, WD800JB
hard disc (ATA connected), the Debian GNU/Hurd is on hda1or hd0s1 (I
hope :-) ), It's a 6 GB (maybe this is it?) ext2 hurd partition.
What is the problem and how can I fix it?
I'll be glade to give more info,
Thanks,
Yuval
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
   

--
 Philip Charles; 39a Paterson Street, Abbotsford, Dunedin, New Zealand
  +64 3 488 2818        Fax +64 3 488 2875        Mobile 025 267 9420
    [EMAIL PROTECTED] - preferred.          [EMAIL PROTECTED]
 I sell GNU/Linux & GNU/Hurd CDs & DVDs.   See http://www.copyleft.co.nz
 


--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]