1) I stopped the computer, removed the Huawei device from the computer, started again and installed another usb device there in the same slot.
2) Started the computer again. And Huawei stopped working. 3) And when giving again the command # usb_modeswitch -J -v 0x12d1 -p 0x157d It started working. 4) What should I do to get it permanently working? -hv -------------------------------------------- On Thu, 2/26/15, Hannu Virtanen <[email protected]> wrote: Subject: Re: Huawei E3372: Success (!) To: "Bjørn Mork" <[email protected]> Cc: "Petr Kubánek" <[email protected]>, [email protected] Date: Thursday, February 26, 2015, 5:40 PM giving: --- --- # usb_modeswitch -J -v 0x12d1 -p 0x157d Look for default devices ... product ID matched Found devices in default mode (1) Access device 006 on bus 007 Current configuration number is 1 Use interface number 0 Use endpoints 0x01 (out) and 0x81 (in) USB description data (for identification) ------------------------- Manufacturer: HUAWEI_MOBILE Product: HUAWEI_MOBILE Serial No.: 0123456789ABCDEF ------------------------- Using standard Huawei switching message Looking for active driver ... OK, driver detached Set up interface 0 Use endpoint 0x01 for message sending ... Trying to send message 1 to endpoint 0x01 ... OK, message successfully sent Reset response endpoint 0x81 --- --- And now it is working(!) Actually I don't know if everything started working only because of with that - J option, because I tried it already once earlier. I have isntalled one firmware from Huawei too during this work... -hv -- To UNSUBSCRIBE, email to [email protected] with a subject of "unsubscribe". Trouble? Contact [email protected] Archive: https://lists.debian.org/[email protected]
