sun_2_buy <[EMAIL PROTECTED]> wrote: > The problem still exists that during the installation (sarge) the > parted tool which is called shows not the posibility to create > linux auto raid partitions.
> I tried to pre - partition the disks using a woody install disk. I > wrote the disklables by using fdisk and then started over with > installing sarge. The Installer (parted) did not recognize the auto > raid partitions. I can confirm the above from a couple of installation attempts I made on a Sun Netra T1 105. The partitioner did not offer the possibility to create partitions of type 0xFD, and if they had been created beforehand the partitioner did not recognise the partition type. -- Best regards, George Karaolides System Administrator OTEnet Telecom 20 Ayias Paraskevis St. CY-2002 Strovolos, Nicosia, Cyprus tel: +357 22 693333 fax: +357 22 455686 www.otenet-telecom.com Confidentiality notice and disclaimer applies: http://www.otenet-telecom.com/Disclaimer.html -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
