Le mer 25/09/2002 à 15:15, Ben Collins a écrit : > > The (strange) problem is: > > 1?) when i don't put the 2nd card in my sparc, all works fine, i can > > dhcp on eth0 > > 2?) when i put the second one, dhcp doesn't work ( eth0 doesn't work: > > linux says "cable problem" ie twisted pairs RJ45 cable). But when i go > > into openprom i can self-test the both ethernet (connected one after one > > to the cable modem), and that's seem good ( i see good ethernet pacquet > > (a dot) and none bad eth pacquet (a X)). > > Are you sure that eth0 really is the card you think it is? Linux does > not order the same as the OBP does. I'm sure, unfortunately i havent the log here (i'm at work). > > If you want to force one card to be eth0, then compile the driver for > that card into the kernel, and compile the other ethernet driver as a > module and load it at boot. I will make test tonight... thanks.
is it a bad idea "ether=.." parameters? Another thing: I've made test with ethtool (good stuff ;) and eth0 seem fine (i can read/modify its conf) but eth1 doesn't work ( i had a message like it is not supported by device!)... that's why i've seen that dhclient put the card in speed=10 autoneg no, etc... > > -- > Debian - http://www.debian.org/ > Linux 1394 - http://www.linux1394.org/ > Subversion - http://subversion.tigris.org/ > Deqo - http://www.deqo.com/ > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > >
