Your message says me that the 7000FASST might not be the cause of the problem.
Well, try this one then # cp .config.save .config # make menuconfig # remove all compiled in SCSI support except aic7xxx # make dep; make clean; make zImage # mv arch/i386/boot/zImage vmlinuz-2.0.36-only-aic7xxx available as ftp://kalle.csb.ki.se/pub/vmlinuz-2.0.36-only-aic7xxx # cp /.../disks-i386/2.1.9-1999-03-03/resc1440.bin . # cp resc1440.bin resc1440.bin-only-aic7xxx # mount -o loop resc1440.bin-only-aic7xxx /mnt # cp vmlinuz-2.0.36-only-aic7xxx /mnt/linux # /mnt/rdev.sh + set -e + readonly Arch=i386 + Arch=i386 + '[' i386 '!=' m68k ']' + rdev -R /mnt/linux 1 + rdev -r /mnt/linux 0 + rdev -v /mnt/linux -1 + rdev /mnt/linux /dev/ram0 # umount /mnt available as ftp://kalle.csb.ki.se/pub/resc1440.bin-only-aic7xxx To save download time, get vmlinuz-2.0.36-only-aic7xxx and do part two yourself. If this does not work, hmm, big problems If this do work, let us include more SCSI support and iterate till we find the one cousing the conflict. Cheers, Karl ------------------------------------------------------------------------------- Karl Hammar Aspö Data [EMAIL PROTECTED] Lilla Aspö 2340 0173 140 57 S-742 94 Östhammar 070 511 97 84 Professionella Linuxlösningar Sweden ------------------------------------------------------------------------------- On Wed, 16 Jun 1999, Eric wrote: > It failed. I booted using 4 different boot prompt parameters: none; > aic7xxx=no_probe; aic7xxx=no_reset; and aic7xxx=no_probe,no_reset. All > four times, the system froze after the "419 instructions downloaded..." > line, for a good minute, which I interpreted as failure. Any more > suggestions? I really want to get Linux running. > > Eric > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
