steef wrote:
Aaron Maxwell wrote:
Hi, I recently upgraded most of the hardware on my system, but pulled
out the cdrom and installed it in the new box. Now I am not able to
mount it successfully. This is a normal ATAPI IDE cdrom drive, and
I'm running testing. The kernel is 2.6.10 and of course has the
atapi driver compiled in.
/dev/hdc is the cdrom device. This is what happens when I try to
mount it:
---
jashenki:~# mount -t iso9660 -r /dev/hdc /mnt/cdrom
mount: wrong fs type, bad option, bad superblock on /dev/hdc,
missing codepage or other error
In some cases useful info is found in syslog - try
dmesg | tail or so
---
The output of dmesg seems to indicate that everything is fine, up
until I try to mount it. Here is the related output:
---
VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:pio
...
Probing IDE interface ide1...
hdc: E-IDE CD-ROM CR-850E, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
...
hdc: ATAPI 50X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.20
---
And then when I attempt the mount this message shows up in dmesg's tail:
---
hdc: command error: status=0x51 { DriveReady SeekComplete Error }
hdc: command error: error=0x54
ide: failed opcode was 100
end_request: I/O error, dev hdc, sector 64
isofs_fill_super: bread failed, dev=hdc, iso_blknum=16, block=16
---
The drive's jumper is set to "cable select". I originally had it set
to master, and changed it to see if it would fix the problem.
Any ideas? Thanks in advance.
peace to you too.
what happens if you leave <-r> out?
steef
i think -too late - of this: if you try to mount an audio-cd this way it
*must* fail
peace to you,
steef
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
