I'm trying to load 1.3.0 on a notebook. I made the boot, driver, and 5 base diskettes. I also made a couple of ext2fs diskettes that had pcmcia-cs_2.9.5-3, pcmcia-modules-2.0.30, and the 2.0.30 kernel-image.
I didn't dslect, or course, since my source was unavailable (was going to NFS mount the CD like I did when I had rex on this notebook). I boot from the 2.0.30 kernel just fine, and don't get any module problems when I depmod -a either. However, when the /etc/init.d/pcmcia script starts, the card & socket services start up fine, until it inserts the module for my ethernet card, a 3c589. I get complaints about 8 symbols that are unresolved. They are: netif_rx_R9117ffb8 dev_alloc_skb_R24e337ab ether_setup... eth_type_trans... dev_kfree_skb... dev_tint.. unregister_netdev... register_netdev... Yet, all of these symbols appear in /System.map, which does point to /boot/System.map-2.0.30, to match /vmlinuz -> /boot/vmlinuz-2.0.30. anyone seen this, overcome it, or what? Jason Costomiris | Finger for PGP 2.6.2 Public Key [EMAIL PROTECTED] | "There is a fine line between idiocy My employers like me, but not | and genius. We aim to erase that line" enough to let me speak for them. | --Unknown http://www.jasons.org/~jcostom -- TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to [EMAIL PROTECTED] . Trouble? e-mail to [EMAIL PROTECTED] .