On Fri, Jun 05, 1998 at 07:49:17PM +0200, Marc van der Vossen wrote: > Hi, > > I have a problem with my secondary IDE channel. I have a CD-rom as slave ans > a Zip-drive as Master on that controller. When I insert my Debian-CD, > install goes OK. Then, after reboot, dselect starts and I say; load from > CD-rom. That's the place it does not work. I tried installing a mitsumi > driver with the following settingns, > mcd=0x376,15 > Is this correct ? > I tried setting CD as Master and Zip as slave, but the system does not run > and I can't even get the dos driver, nor the win95 driver to work. >
I have the same configuration. It worked fine until I upgraded to a TX motherboard. After that Linux would not recognize my cdrom drive. I finally got it workin with the cdrom as slave to the zip, and added this line to my /tec/lilo.conf: append="hdc=cdrom" It gives me a warning or two at bootup, but every thing works fine. -- Mike Schmitz [EMAIL PROTECTED] http://www.bend-or.com/~mschmitz Don't blame me - I voted libertarian! http://www.lp.org/ Use Debian Linux - the free Gnu/Linux http://www.debian.org/ ----------- "If encryption is outlawed, only outlaws will have encryption" -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]