On %M 0, MR wrote > /etc/lilo.conf now looks like: > > boot=/dev/hda1 > root=/dev/hda1 > install=/boot/boot.b > map=/boot/map > vga=normal > delay=20 > image=/vmlinuz > label=Linux > read-only > append="ether=11,0x300,eth0 ether=10,0x240,eth1" > > ran liloconfig and let it install a boot block using the current lilo config. > > rebooted.. and only 1 card is picked up (looks like nothing changed) > > -Matt >
At the risk of seeming obtuse this will only work if the drivers are compiled into the kernel, rather than loaded as modules. If you are using modules, you need to edit files in /etc/modutils and run update-modules to get the second card working. If this is the case, you probably need to change a line that looks like options eexp io=0x300 to options eexp io=0x300,0x240 or so. If you're not sure if it's loaded as a module, run lsmod and see if it lists 'eexp'; if it does, it's a module. If you're using a stock kernel, it's loaded as a module. Good luck, John P. -- [EMAIL PROTECTED] [EMAIL PROTECTED] "Oh - I - you know - my job is to fear everything." - Bill Gates in Denmark