Is is worth upgrading to 4.0?
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf
Of Peter Good
Sent: Thursday, June 22, 2000 4:44 PM
To: Colin Watson; [email protected]
Subject: Re: Problem with XFree 4.0 .
(snipped from the XFree86 4.0 Install file)
The next step is to configure the X server. That is covered in detail
in an
as-yet unwritten document :-(. In the meantime, there are two ways to
create
a basic X server configuration file for XFree86 4.0. One is to run the
xf86config utility. Another is to use the new -configure X server
option:
XFree86 -configure
(End of snip)
Thats where he would have got that command from.
Peter.
Colin Watson wrote:
>
> G0DModE <[EMAIL PROTECTED]> wrote:
> >After unpacking the XFree 4.0 soft, I wanted to configure it, so I run
> >"XFree86 -configure" command and the output was: "Segmentation fault". I
> >tried to install over and over again, but always output was the same.
>
> Where did you get that command from? :)
>
> The XFree86 executable in 4.0 doesn't have a -configure option. Try
> editing /etc/X11/XF86Config (its location may depend on how you
> installed XFree86). Or, if you're trying to build from source, read
> INSTALL.TXT.
>
> All the details should be in the very comprehensive documentation.
>
> --
> Colin Watson [EMAIL PROTECTED]
--
On The Other hand, you have fingers :)
*Peter Good Email: [EMAIL PROTECTED]
*Pete's Internet Services Sales: [EMAIL PROTECTED] *
--
Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] <
/dev/null
