Hi Folks;
The Zip Drive uses a separate parallel port card to which it is
plugged into (works under Windows 98). I have added the
io=0x278 to "modules.conf", and run "depmod -a" to update
the "modules.dep". As shown below the new ioport is
recognized by /proc/parport/1/hardware. What do I have to
do to get the ioport accepted by parport_pc?
[EMAIL PROTECTED]:/home/clay > modprobe parport_pc
[EMAIL PROTECTED]:/home/clay > lsmod
Module Size Used by
parport_pc 7440 0 (unused)
parport 7432 0 [parport_pc]
[EMAIL PROTECTED]:/home/clay > mount /zip
mount: the kernel does not recognize /dev/sda4 as a block device
(maybe `insmod driver'?)
[EMAIL PROTECTED]:/home/clay > less /proc/parport/0/hardware
base: 0x378
irq: none
dma: none
modes: SPP,ECP,ECPEPP,ECPPS2
[EMAIL PROTECTED]:/home/clay > less /proc/parport/1/hardware
base: 0x278
irq: none
dma: none
modes: SPP,PS2
[EMAIL PROTECTED]:/home/clay > less /etc/fstab
/dev/sda4 /zip ext2 defaults 0 0
/dev/sda4 /zipdos vfat defaults 0 0
TIA
Clay Stapleton
