Seth Goodman wrote:
From: Wackojacko [mailto:[EMAIL PROTECTED]
Sent: Thursday, September 22, 2005 2:52 PM
<...>
A quick look at the kernel-source (via make menuconfig) and google
suggest that PIIX could be the right module. I dont have this mobo so I
cant be sure.
I don't see a 82371 on this board. Rather, it has a FW82801AA.
The ide controller is picked up in dmesg as ICH and
http://www.linux-laptop.net/hosted/fs215e-slackware.html (I know its a
laptop) suggests this module for the same chipset. The help for this
kernel module says
CONFIG_BLK_DEV_PIIX:
This driver adds explicit support for Intel PIIX and ICH chips
and also for the Efar
Victory66 (slc90e66) chip. This allows
the kernel to change PIO, DMA and UDMA speeds and
to configure the chip
to optimum performance.
Symbol: BLK_DEV_PIIX [=n]
Prompt: Intel PIIXn chipsets
support
Defined at drivers/ide/Kconfig:592
Depends on:
IDE && BLK_DEV_IDE && BLK_DEV_IDEDMA_PCI
Location:
-> Device Drivers
-> ATA/ATAPI/MFM/RLL support
-> ATA/ATAPI/MFM/RLL support (IDE [=y])
-> Enhanced
IDE/MFM/RLL disk/cdrom/tape/floppy support (BLK_DEV_IDE [=y])
-> PCI IDE chipset support (BLK_DEV_IDEPCI [=y])
- > Generic PCI
bus-master DMA support (BLK_DEV_IDEDMA_PCI [=y])
Here is the file system table (I shortened the hda1 line to fit):
# /etc/fstab: static file system information.
#
# <file system> <mount point> <type> <options> <dump> <pass>
proc /proc proc defaults 0 0
/dev/hda1 / ext3 defaults,errors=remount-ro 0 1
/dev/hda5 none swap sw 0 0
/dev/hdc /media/cdrom0 iso9660 ro,user,noauto 0 0
/dev/fd0 /media/floppy0 auto rw,user,noauto 0 0
<snip mount attempts>
isofs_fill_super: bread failed, dev=hdc, iso_blknum=16, block=16
Googling this error (google is always your friend :) ) suggested that
- you may want to turn DMA off for the drive ' hdparm -d0 /dev/hdc'.
May need to install 'hdparm' first.
- hal (hardware extraction layer) deamon can cause this trouble so try
stopping haldeamon if installed.
- trying to mount audio CD which has no file system, not relevant in
this instance.
It tries, but it really doesn't want to mount. Your hypothesis of an extra
driver that interferes is reasonable.
Try the above first, if this doesn't work I would go for a compiled
kernel, starting with the config file in /boot/config-`uname -r` and
remove all of the modules apart from PIIX which should be compiled in.
Wackojacko
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]