--- Land Haj <[EMAIL PROTECTED]> wrote: > Hi! > > Back at work I just upgraded my sarge installation to etch. I changed the > sources for apt, did apt-get update, apt-get install aptitude and aptitude -f > --with-recommends dist-upgrade. > > All has gone fine, but when I start to work, I discover a problem with my > main > tool: kdvi. It can't seem to render my documents properly. Each time I load a > document, it needs to generate the bitmap fonts for 1200 dpi. It does this > every time even if it's the same document. And when it's done I can't see the > fonts, just som square blobs. I have no trouble opening these doucments on my > laptop or at home, which also run etch. > > xdvi (here at work) generates the fonts perfectly, and I have no trouble > running latex on the .tex sources either. > > Does someone know what's going on? > > Please help! > > /landhaj > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED] > >
I found out the problem, just in case someone else encounters it: Apparently, the config file for updmap had been overwritten, so my custom fonts didn't work. Adding the .map entries to the config file and updating updmap fixed the problem. /landhaj __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]