Hi everybody,
Well I finally made the upgrade to Lenny, and my USB printers only work when
the ehci_hcd module is loaded after the printer is on. If I set it to load a
boot and the printer's off, I have to "rmmod ehci_hcd; modprobe ehci_hcd" once
the printer is on again before it will work.
Before the upgrade to Lenny, everything was going fine. I have an HP
LaserJet 4MPlus connected with a parallel-to-USB cable. CUPS is fine. But if
ehci_hcd isn't loaded (or if it's loaded before the printer is one), when I
send a print job it's always just "processing" forever, and nothing is actually
sent to the printer until that module gets reloaded.
Is there a way to make it automagically reload when a USB printer goes on?
Or is there another fix to this problem?
I appreciate the help. This has me stumped!
THANK YOU SO MUCH!
Jen
--
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]
Archive: http://lists.debian.org/[email protected]
