I have a Broadcomm4310. I did this and it works. It is too damn bad if you don't like the top post.
BEGIN CODE aptitude update aptitude install module-assistant wireless-tools m-a a-i broadcom-sta echo blacklist brcm80211 >> /etc/modprobe.d/broadcom-sta-common.conf update-initramfs -u -k $(uname -r) modprobe -r b44 b43 b43legacy ssb mac80211 modprobe wl iwconfig END CODE Mike On Sunday, May 25, 2014 22:24:48 tom arnall wrote: > I poked around a bit more at the Debian wiki and some other places and > found out about Broadcom wireless devices and that they have problems. > > Here is what I did about it and the results. I'm using all caps for my > remarks to keep them apart from the rest of the text. (My card works. > I checked it with my Windows partition.) > > > MY CARD: > > #discover|grep Broadcom > Broadcom Corporation BCM4311 802.11b/g WLAN > > > > DMESG SHOWED THAT I DIDN'T HAVE THE RIGHT DRIVERS INSTALLED, SO I DID > THIS FROM https://wiki.debian.org/wl#Debian_7_.22Wheezy.22: > > Add a "non-free" component to /etc/apt/sources.list, for example: > # Debian 7 "Wheezy" > deb http://http.debian.net/debian/ wheezy main contrib non-free > Update the list of available packages. Install the relevant > linux-headers and broadcom-sta-dkms packages: > # apt-get update > # apt-get install linux-headers-$(uname -r|sed 's,[^-]*-[^-]*-,,') > broadcom-sta-dkms > This will also install the recommended wireless-tools package. DKMS > will build the wl module for your system. > Unload conflicting modules: > # modprobe -r b44 b43 b43legacy ssb brcmsmac > Load the wl module: > # modprobe wl > Configure your wireless interface as appropriate. See also known issues. > > > > I REBOOTED AND DID THE LAST TWO COMMANDS. > I FIRED UP WICD AND GOT THE USUAL "No wireless networks found." > > > > THEN I CHECKED TO SEE THE STATUS OF THE DEVICE. VOILA! IT'S NOT THERE, AS > IN: > > Root@debian:/home/tom# ifconfig -a > eth0 Link encap:Ethernet HWaddr 00:1c:23:2f:f3:8f > inet addr:192.168.0.14 Bcast:192.168.0.255 Mask:255.255.255.0 > inet6 addr: fe80::21c:23ff:fe2f:f38f/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:11712 errors:0 dropped:0 overruns:0 frame:0 > TX packets:12194 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:6002427 (5.7 MiB) TX bytes:3623290 (3.4 MiB) > Interrupt:17 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:23 errors:0 dropped:0 overruns:0 frame:0 > TX packets:23 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:1743 (1.7 KiB) TX bytes:1743 (1.7 KiB) > > AND: > > root@debian:/home/tom# iwconfig > lo no wireless extensions. > > eth0 no wireless extensions. > > > HERE IS THE CURRENT DMESG OUTPUT WHICH SEEMS TO BE RELEVANT: > > [ 8.833067] input: AlpsPS/2 ALPS DualPoint TouchPad as > /devices/platform/i8042/serio1/input/input13 > [ 8.929734] wl: module license 'MIXED/Proprietary' taints kernel. > [ 8.929740] Disabling lock debugging due to kernel taint > [ 8.941586] wl 0000:0c:00.0: setting latency timer to 64 > [ 8.944209] wlan%d: 5.100.82.112 driver failed with code 21 > [ 8.944230] ------------[ cut here ]------------ > [ 8.944284] kernel BUG at > /usr/src/linux-headers-3.2.0-4-common/include/net/cfg80211.h:2209! > [ 8.944340] invalid opcode: 0000 [#1] SMP > [ 8.944478] CPU 1 > [ 8.944524] Modules linked in: wl(P+) drm_kms_helper drm > yenta_socket pcmcia_rsrc iTCO_wdt snd_hda_codec_idt i2c_algo_bit > dell_laptop dell_wmi pcmcia_core iTCO_vendor_support coretemp > snd_hda_intel snd_hda_codec snd_hwdep snd_pcm snd_page_alloc psmouse > acpi_cpufreq i2c_i801 serio_raw lib80211 ac i2c_core evdev > sparse_keymap pcspkr dcdbas mperf cfg80211 snd_seq snd_seq_device > snd_timer rfkill snd battery wmi soundcore power_supply video > processor button ext4 crc16 jbd2 mbcache sg sr_mod cdrom sd_mod > crc_t10dif thermal usbhid hid thermal_sys ata_generic firewire_ohci > ata_piix firewire_core crc_itu_t uhci_hcd ehci_hcd libata tg3 libphy > scsi_mod usbcore usb_common [last unloaded: scsi_wait_scan] > [ 8.947779] > [ 8.947827] Pid: 514, comm: modprobe Tainted: P O > 3.2.0-4-amd64 #1 Debian 3.2.57-3 Dell Inc. Latitude D630 > /0KU184 > [ 8.948007] RIP: 0010:[<ffffffffa0418a9d>] [<ffffffffa0418a9d>] > wdev_priv+0x5/0xf [wl] > [ 8.948007] RSP: 0018:ffff880037133c00 EFLAGS: 00010246 > [ 8.948007] RAX: ffff88007b254800 RBX: ffff88007b254f40 RCX: > 0000000000000990 [ 8.948007] RDX: 0000000000000000 RSI: > ffff88007b254f40 RDI: 0000000000000000 [ 8.948007] RBP: > ffff880036c4d400 R08: 0000000000000002 R09: 00000000fffffffe [ > 8.948007] R10: 0000000000000000 R11: ffff8800370b6000 R12: > ffff88007b254800 [ 8.948007] R13: 0000000000000000 R14: > ffff88007b613ac0 R15: 0000000000000011 [ 8.948007] FS: > 00007f48bc96d700(0000) GS:ffff88007f500000(0000) knlGS:0000000000000000 > [ 8.948007] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 > [ 8.948007] CR2: 00007f48bc1c8000 CR3: 000000003716a000 CR4: > 00000000000006e0 [ 8.948007] DR0: 0000000000000000 DR1: > 0000000000000000 DR2: 0000000000000000 [ 8.948007] DR3: > 0000000000000000 DR6: 00000000ffff0ff0 DR7: 0000000000000400 [ > 8.948007] Process modprobe (pid: 514, threadinfo > ffff880037132000, task ffff880036dc5100) > [ 8.948007] Stack: > [ 8.948007] ffffffffa041cc8b ffff88007b254800 ffff88007b254f40 > ffff880036c4d400 > [ 8.948007] ffffffffa041694b ffff88007b254800 ffff880036c4d400 > ffff88007c14e000 > [ 8.948007] ffffffffa0417189 ffff880037133ce8 0000000022b0b063 > ffffc90000340000 > [ 8.948007] Call Trace: > [ 8.948007] [<ffffffffa041cc8b>] ? wl_cfg80211_detach+0xf/0xb6 [wl] > [ 8.948007] [<ffffffffa041694b>] ? wl_free_if+0x27/0x7e [wl] > [ 8.948007] [<ffffffffa0417189>] ? wl_free+0x51/0x201 [wl] > [ 8.948007] [<ffffffff81349231>] ? printk+0x43/0x48 > [ 8.948007] [<ffffffffa041d669>] ? wl_pci_probe+0x485/0x4b0 [wl] > [ 8.948007] [<ffffffff8134fa6f>] ? _raw_spin_unlock_irqrestore+0xe/0xf > [ 8.948007] [<ffffffff81259e12>] ? __pm_runtime_set_status+0x118/0x13c > [ 8.948007] [<ffffffff811c700f>] ? local_pci_probe+0x39/0x68 > [ 8.948007] [<ffffffff811c7ab8>] ? pci_device_probe+0xcd/0xfa > [ 8.948007] [<ffffffff812524ad>] ? driver_probe_device+0xa8/0x138 > [ 8.948007] [<ffffffff8125258c>] ? __driver_attach+0x4f/0x6f > [ 8.948007] [<ffffffff8125253d>] ? driver_probe_device+0x138/0x138 > [ 8.948007] [<ffffffff812510dc>] ? bus_for_each_dev+0x4f/0x7a > [ 8.948007] [<ffffffff81251e46>] ? bus_add_driver+0xa5/0x1f5 > [ 8.948007] [<ffffffffa05bb000>] ? 0xffffffffa05bafff > [ 8.948007] [<ffffffff812529b4>] ? driver_register+0x8d/0xf5 > [ 8.948007] [<ffffffffa05bb000>] ? 0xffffffffa05bafff > [ 8.948007] [<ffffffff811c82d3>] ? __pci_register_driver+0x4d/0xb6 > [ 8.948007] [<ffffffffa05bb000>] ? 0xffffffffa05bafff > [ 8.948007] [<ffffffff81002085>] ? do_one_initcall+0x75/0x12c > [ 8.948007] [<ffffffffa05bb000>] ? 0xffffffffa05bafff > [ 8.948007] [<ffffffff81075981>] ? sys_init_module+0x10c/0x25b > [ 8.948007] [<ffffffff81354a12>] ? system_call_fastpath+0x16/0x1b > [ 8.948007] Code: b5 08 07 00 00 48 c7 c7 ad c4 56 a0 31 c0 e8 69 > 07 f3 e0 eb 0a 4c 89 e7 31 db e8 ec f7 ff ff 89 d8 5b 5d 41 5c c3 48 > 85 ff 75 02 <0f> 0b 48 8b 3f e9 9e fe ff ff 41 54 41 89 c8 55 53 48 89 > fb 48 > [ 8.948007] RIP [<ffffffffa0418a9d>] wdev_priv+0x5/0xf [wl] > [ 8.948007] RSP <ffff880037133c00> > [ 8.954564] ---[ end trace 1fb03c896022003d ]--- > > > > > I AM NOW STUMPED ;o( -- Mike McGinn KD2CNU Be happy that brainfarts don't smell. No electrons were harmed in sending this message, some were inconvenienced. ** Registered Linux User 377849 -- To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org Archive: https://lists.debian.org/201405260950.36933.mikemcg...@mcginnweb.net