Le 10/08/2016 à 14:43, Tom Browder a écrit :
$ ip -4 addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UP group default qlen 1000
inet 192.168.0.17/24 brd 192.168.0.255 scope global eth0
valid_lft forever preferred_lft forever
Well, it it looks like I was right.
Is there confusion in my Debian 8 between networking setting methods
(ip ves ifconfig)?
What makes you think this ? Does ifconfig display the additional
addresses ? I doubt it.
Reading again your original message, IIRC the "restart" action acts only
on interfaces configured with "auto" or "allow-auto", not
"allow-hotplug". This is the reason of the big warning displayed when
you run the command.
Should I understand that by "all went well" you just meant there was no
error message but you did not check the actual interface configuration ?
Did you reboot the system ? If not, try this :
ifup --force eth0
