On Monday 12 April 2021 00:27:12 Mirco Piccin wrote: > Hi, > Have you tried uploading the firmware to the board again? > No, haven't got it and the makers site may as well be the install boilerplate, nothing is available under the support button, and the email address, while valid, is not accepting email, I have at least 5 bounces because it was undeliverable. IOW, I got screwed for another $400 again. Dremel has no support for their digilab stuff and I bought thier best at $1900. So its out of the way and my ender 3 is back on the table. Its sorta working, but this printer has about 4x the working volume of an ender 3.
I've looked up the codes and written a 30 line program that may help troubleshhot, when I have both eyes open at the same time much later today. The power supply is good, but its not now heating anything and throwing errors 4 and 5 because of that. OOTB, it worked once but didn't make a good print because the Z offset was about 3 or 4mm below the bed. If I could log into it with cutecom or such, I might be able to get a little shmartder ;-) Thanks Mirco Piccin. > On Mon, Apr 12, 2021, 05:55 Gene Heskett <[email protected]> wrote: > > Greetings all; > > > > Building a design/builder for a 3d printer, which when a std usb to > > printer cable is connected between the computer and the 3d printer, > > Identifies as a ch341 convertor cable once it is plugged into the > > printer. > > > > conman seems helpless, as does cutecom. > > > > cura has a monitor that can drive an ender 3 over this same cable > > but I've not been able to establish a connection to cura, for > > whatever reason. > > > > Perhaps conman or cutecom is not the correct way to do it. IDK, and > > the docs for this printer are as non-existant as the chinese company > > that made it. Its labeled as a NEWEREAL M-18-S, and is nearly twice > > as big as an ender 3. Work envelope is 310x310x400mm, and is the > > same bed-slinger style as an ender 3. > > > > What would the next thing to try and discover why its not working? > > > > Cheers, Gene Heskett > > -- > > "There are four boxes to be used in defense of liberty: > > soap, ballot, jury, and ammo. Please use in that order." > > -Ed Howdershelt (Author) > > If we desire respect for the law, we must first make the law > > respectable. - Louis D. Brandeis > > Genes Web page <http://geneslinuxbox.net:6309/gene> Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene>
