Am Sat, 17 Jan 2004 08:10:06 +0100 schrieb Andreas Janssen: > Hello > > Thomas Sommer (<[EMAIL PROTECTED]>) wrote: > >> after reading a lot of howtos, newsgroups, etc. i constandly have the >> following problem with my cdrw-drive (when i try to mount it): >> >> dusk:/# mount /dev/cdrw >> mount: /dev/scd0 ist kein g�ltiges blockorientiertes Ger�t >> (english: is not a valid block device) >> >> scsi-ide-module is installed proper, and i even can burn cds with the >> drive. >> >> fstab: >> ---snip--- >> /dev/cdrw /cdrom iso9660 ro,user,noauto 0 0 >> ---snip--- > > First, check where /dev/cdrw is pointing to. After activating ide-scsi, > it should point to /dev/scd0 or /dev/scd1 instead of /dev/hd*, > depending on the amount of drives you activated ide-scsi for.
cdrw -> /dev/scd0 > Second, depending on your Kernel, make sure you told the ide-cd driver > to ignore the CDRW drive. If the ide-cd driver is compiled into the > Kernel (e.g. installation Kernel), configure your bootloader: > > append="hdc=ide-scsi" #(if hdc is your cdrw) already before my post to this group done > If you use lilo, run it from the command line after changing the > configuration. This will also work if ide-cd is compiled as a module. > > If you use a module only configuration (ide-cd as a module), you can > also make sure that either > > ide-cd does not get loaded before ide-scsi > > ide-cd is told to ignore the cdrw. Add > > options ide-cd ignore=hdc > > To some file in /etc/modutils and run update modules. I don't think that that will solve the problem, because i actually can burn cds with cdrecord or cdbakeoven but can't read from the same drive > best regards > Andreas Janssen Thx so far Thomas -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
