Hi, Wenzhuo,
I'm sorry, but I have more even harder questions than the previous one.
This questions are rather generic and mainly to ethdev maintainers.
On 13.07.2018 05:42, Wenzhuo Lu wrote:
The device information cannot be gotten correctly before
the configuration is set. Because on some NICs the
information has dependence on the configuration.
Thinking about it I have the following question. Is it valid behaviour
of the dev_info if it changes after configuration?
I always thought that the primary goal of the dev_info is to
provide information to app about device capabilities to allow app
configure device and queues correctly. Now we see the case when
dev_info changes on configure. May be it is acceptable, but it is
really suspicious. If we accept it, it should be documented.
May be dev_info should be split into parts: part which is persistent and
part which may depend on device configuration.
Fixes: 3be82f5cc5e3 ("ethdev: support PMD-tuned Tx/Rx parameters")
Signed-off-by: Wenzhuo Lu <wenzhuo...@intel.com>
---
lib/librte_ethdev/rte_ethdev.c | 21 +++++++++++----------
1 file changed, 11 insertions(+), 10 deletions(-)
diff --git a/lib/librte_ethdev/rte_ethdev.c b/lib/librte_ethdev/rte_ethdev.c
index 3d556a8..6f606c1 100644
--- a/lib/librte_ethdev/rte_ethdev.c
+++ b/lib/librte_ethdev/rte_ethdev.c
@@ -1022,6 +1022,17 @@ struct rte_eth_dev *
RTE_FUNC_PTR_OR_ERR_RET(*dev->dev_ops->dev_infos_get, -ENOTSUP);
RTE_FUNC_PTR_OR_ERR_RET(*dev->dev_ops->dev_configure, -ENOTSUP);
+ if (dev->data->dev_started) {
+ RTE_ETHDEV_LOG(ERR,
+ "Port %u must be stopped to allow configuration\n",
+ port_id);
+ return -EBUSY;
+ }
+
+ /* Copy the dev_conf parameter into the dev structure,
+ * then get the info.
+ */
+ memcpy(&dev->data->dev_conf, &local_conf, sizeof(dev->data->dev_conf));
It is not a problem of the patch, but I'd like to highlight it to Ferruh
and
Thomas. What we have in the case of below failures? State is really
inconsistent in the case of reconfigure. We have applied new dev_conf,
but we still have previous Rx/Tx queues which were setup before.
rte_eth_dev_info_get(port_id, &dev_info);
/* If number of queues specified by application for both Rx and Tx is
@@ -1053,16 +1064,6 @@ struct rte_eth_dev *
return -EINVAL;
}
- if (dev->data->dev_started) {
- RTE_ETHDEV_LOG(ERR,
- "Port %u must be stopped to allow configuration\n",
- port_id);
- return -EBUSY;
- }
-
- /* Copy the dev_conf parameter into the dev structure */
- memcpy(&dev->data->dev_conf, &local_conf, sizeof(dev->data->dev_conf));
-
/*
* Check that the numbers of RX and TX queues are not greater
* than the maximum number of RX and TX queues supported by the
