When jumbo frames is configured, the hardware mtu needs to be updated to the specified max_rx_pkt_len. Also, changing mtu should be avoided once the PMD port started.
Fixes: defb9a5dd156 ("nfp: introduce driver initialization") Signed-off-by: Alejandro Lucero <alejandro.luc...@netronome.com> --- drivers/net/nfp/nfp_net.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) diff --git a/drivers/net/nfp/nfp_net.c b/drivers/net/nfp/nfp_net.c index 9a7b0b2..e2cea06 100644 --- a/drivers/net/nfp/nfp_net.c +++ b/drivers/net/nfp/nfp_net.c @@ -489,7 +489,7 @@ enum nfp_qcp_ptr { } if (rxmode->jumbo_frame) - /* this is handled in rte_eth_dev_configure */ + hw->mtu = rxmode->max_rx_pkt_len; if (rxmode->hw_strip_crc) { PMD_INIT_LOG(INFO, "strip CRC not supported"); @@ -1469,6 +1469,13 @@ enum nfp_qcp_ptr { if ((mtu < ETHER_MIN_MTU) || ((uint32_t)mtu > hw->max_mtu)) return -EINVAL; + /* mtu setting is forbidden if port is started */ + if (dev->data->dev_started) { + PMD_DRV_LOG(ERR, "port %d must be stopped before configuration", + dev_data->port_id); + return -EBUSY; + } + /* switch to jumbo mode if needed */ if ((uint32_t)mtu > ETHER_MAX_LEN) dev->data->dev_conf.rxmode.jumbo_frame = 1; -- 1.9.1