Yes I have done all the above exactly as you have given and have the execpected results.
Then from my reading here http://mynewt.apache.org/os/get_started/project1/#build-test-code-on-simulator it says I should run the following $ cd ~/dev/larva/hw/bsp/olimex_stm32-e407_devboard $ diff olimex_stm32-e407_devboard.ld run_from_sram.ld $ cp run_from_sram.ld olimex_stm32-e407_devboard.ld $ cd ~/dev/larva/project/blinky/ all the above commands give me expected output. now when I run $ newt target build blinky I get the following error Error: No configuration section exists so I do not understand what the error is. On 3/4/16, Christopher Collins <[email protected]> wrote: > Hi Nges, > > Did you create the 'blinky' target using newt? This process is a bit of > a hassle at the moment, but you only have to do it once. > > The following set of commands should do the trick: > > $ newt target create blinky > $ newt target set blinky arch=cortex_m4 > $ newt target set blinky compiler=arm-none-eabi-m4 > $ newt target set blinky project=blinky > $ newt target set blinky compiler_def=debug > $ newt target set blinky bsp=hw/bsp/olimex_stm32-e407_devboard > > > From http://mynewt.apache.org/os/get_started/project1/ : > > $ newt target create blinky > Creating target blinky > Target blinky sucessfully created! > $ newt target set blinky arch=cortex_m4 > Target blinky successfully set arch to arm > $ newt target set blinky compiler=arm-none-eabi-m4 > Target blinky successfully set compiler to arm-none-eabi-m4 > $ newt target set blinky project=blinky > Target blinky successfully set project to blinky > $ newt target set blinky compiler_def=debug > Target blinky successfully set compiler_def to debug > $ newt target set blinky bsp=hw/bsp/olimex_stm32-e407_devboard > Target blinky successfully set bsp to hw/bsp/olimex_stm32-e407_devboard > $ newt target show blinky > blinky > arch=cortex_m4 > bsp=hw/bsp/olimex_stm32-e407_devboard > compiler=arm-none-eabi-m4 > compiler_def=debug > name=blinky > project=blinky > > Chris > > On Fri, Mar 04, 2016 at 02:04:56AM +0100, Nges B wrote: >> Have successfully run all the commands needed for the blinky project. >> Now wen I run $ newt target build blinky >> i get the error "Error: No configuration section exists" >> Please can somebody help me and Identify where I went wrong or I need >> to to to get the Configuration section exists? >> Thanks in advance > -- "it is good to dream and work for the dreams than not to dream"
