Nges, The good news is that this shows that you are connecting to the board and issuing commands to the target.
The bad news is that the command Œat91samd boot loader 0` is not working on your openocd version. We are using 0.9.0. If you are using 0.8.0, Please upgrade to 0.9.0 and try again. Paul On 4/12/16, 11:57 AM, "Nges B" <[email protected]> wrote: >Info : only one transport option; autoselect 'cmsis-dap' >Info : CMSIS-DAP: SWD Supported >Info : CMSIS-DAP: JTAG Supported >Info : CMSIS-DAP: Interface Initialised (SWD) >adapter speed: 500 kHz >adapter_nsrst_delay: 100 >cortex_m reset_config sysresetreq >Info : CMSIS-DAP: FW Version = 01.1F.0118 >Info : SWCLK/TCK = 1 SWDIO/TMS = 1 TDI = 1 TDO = 1 nTRST = 0 nRESET = 1 >Info : DAP_SWJ Sequence (reset: 50+ '1' followed by 0) >Info : CMSIS-DAP: Interface ready >Info : clock speed 500 kHz >Info : IDCODE 0x0bc11477 >Info : at91samd21g18.cpu: hardware has 4 breakpoints, 2 watchpoints >target state: halted >target halted due to debug-request, current mode: Thread >xPSR: 0x81000000 pc: 0x000028f4 msp: 0x20002c00 >at91samd bootloader 0: command requires more arguments >in procedure 'at91samd' >Error: exit status 1
