On Tue, 2017-01-31 at 13:44 -0600, Chris Adams wrote: > Once upon a time, Matthew Miller <[email protected]> said: > > > > I would like the "User Experience" section to be fleshed-out a bit > > more. Currently it says "There should be no visible change for > > non-expert users. Expert users could make use of the new LVM RAID's > > features." > > At a minimum, it would be nice to have a list of common tasks, > especially in a comparison format (e.g. "Replace a failed drive" with > MD and LVM commands). Maybe this already exists somewhere and could > just be referenced. I'm not aware of any such document. CC'ing LVM guys to correct me if I'm wrong.
> > I think one thing that's a bit of an annoyance is that LVM RAID is done > at the LV layer, so you have to remember to set it up for every LV you > create, vs. MD RAID where the whole VG will have RAID (this can be > useful in some situations, but probably not the common case). This > should be pointed out in the release notes IMHO. It's a good idea to mention this in the release notes, thanks! However, a linear LV can be simply converted to a RAID LV later so at least it's not that fatal. > > Also: does this apply to /boot partition RAID 1? IIRC that didn't work > with LVM RAID at one time. /boot on LVM is not supported right now so this is not concerning /boot at all. -- Vratislav Podzimek Anaconda Rider | Red Hat, Inc. | Brno - Czech Republic _______________________________________________ devel mailing list -- [email protected] To unsubscribe send an email to [email protected]
