Hi, all Ok. I need to reconfigure authsae in htmode to HT20 and transmission rate increased up to 104Mbps with TCP throughput about 7Mbps.
But as Thomas pointed out, aggregation is not working. Regards, Chun-Yeow On Fri, Nov 4, 2011 at 9:04 AM, Yeoh Chun-Yeow <[email protected]>wrote: > Hi, all > > I have captured the packet via Wireshark. It shows that the bit rate used > by the two mesh nodes is 6Mbps. That's why the throughput is low. > > Regards, > Chun-Yeow > > On Fri, Nov 4, 2011 at 1:50 AM, Thomas Pedersen <[email protected]>wrote: > >> It seems ADDBA requests are dropped by a peer when security is >> enabled, thanks for reporting this! >> >> Thomas >> >> On Thu, Nov 3, 2011 at 9:41 AM, Thomas Pedersen <[email protected]> >> wrote: >> > Hi Chun-Yeow, >> > >> >> Using authsae, I only managed to get 4Mbps. However, without SAE, I >> managed >> >> to obtain 60Mbps using iperf 10 parallel TCP streams. >> >> Others are getting the same results? It seems that performance drop is >> too >> >> significant. >> > >> > Did you set the correct channel type with iw before bringing up authsae? >> > >> > Thomas >> > >> > >
_______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
