Hi, Thomas Any changes on the ft-ht-mesh + ft-mesh-fixes recently.
I did a test with wireshark and for secured mesh, it seems that the ADDBA request is not there. Regards, Chun-Yeow On Wed, Nov 9, 2011 at 5:13 AM, Thomas Pedersen <[email protected]> wrote: > Hi Chun-Yeow, > > Have you had any success? > > I did not have time to properly to properly test throughput in a > secure mesh laste time, but now with our ft-ht-mesh + ft-mesh-fixes > branches, I'm seeing 55.5Mb/s TCP throughput with a 243Mb/s datarate. > Throughput in the non-secure case is more like at least 100Mb/s, so it > seems we have quite a bit of overhead. > > Thomas > > On Thu, Nov 3, 2011 at 6:28 PM, Yeoh Chun-Yeow <[email protected]> > wrote: > > Hi, all > > Ok. I need to reconfigure authsae in htmode to HT20 and transmission rate > > increased up to 104Mbps with TCP throughput about 7Mbps. > > But as Thomas pointed out, aggregation is not working. > > Regards, > > Chun-Yeow > > > > On Fri, Nov 4, 2011 at 9:04 AM, Yeoh Chun-Yeow <[email protected]> > > wrote: > >> > >> Hi, all > >> I have captured the packet via Wireshark. It shows that the bit rate > used > >> by the two mesh nodes is 6Mbps. That's why the throughput is low. > >> Regards, > >> Chun-Yeow > >> On Fri, Nov 4, 2011 at 1:50 AM, Thomas Pedersen <[email protected]> > >> wrote: > >>> > >>> It seems ADDBA requests are dropped by a peer when security is > >>> enabled, thanks for reporting this! > >>> > >>> Thomas > >>> > >>> On Thu, Nov 3, 2011 at 9:41 AM, Thomas Pedersen <[email protected]> > >>> wrote: > >>> > Hi Chun-Yeow, > >>> > > >>> >> Using authsae, I only managed to get 4Mbps. However, without SAE, I > >>> >> managed > >>> >> to obtain 60Mbps using iperf 10 parallel TCP streams. > >>> >> Others are getting the same results? It seems that performance drop > is > >>> >> too > >>> >> significant. > >>> > > >>> > Did you set the correct channel type with iw before bringing up > >>> > authsae? > >>> > > >>> > Thomas > >>> > > >> > > > > >
_______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
