On Sun, Nov 13, 2011 at 1:11 AM, Zaki <[email protected]> wrote: > Hi, > Hi Zaki,
> Did some thorough throughput testing, here are my setup : > > 1) Processor : PowerQuicc2 Pro MPC8315E > 2) Clock speed : 400 MHz. > 3) Running buildroot linux for powerpc. > 4) WLAN card : Mini-PCI Atheros AR9160 > 5) Channel 36 > 6) Channel Type : HT40+ > 7) Rate control algorithm used : 11n Minstrel > 8) Testing method : Wireless > Do you have crda installed and configured to set the proper regulatory domain for your card? The PHY might not transmit at full power levels otherwise. > Here are my results : > > With AuthSAE : 10 parallel iperf summed up to 14.5 Mbps (max i can > achieved) > Without AuthSAE : 10 parallel iperf summed up to 62 Mbps (max i can > achieved) > We're currently investigating the lowered throughput seen with authSAE, patches are also welcome on this. > The Tx Bitrate reported is around 65 - 300 Mbps. Done the tests on 3 boards > with consistent result. > > Just concern that are these considered the correct expected output for > Meshput release?. > Is there any aggregated PDU setting that i can try with? > > Thanks & Rgds, > Zaki. > > > _______________________________________________ > Devel mailing list > [email protected] > http://open80211s.com/mailman/listinfo/devel > > _______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
