> I just observed this "NL80211_CMD_SET_STATION in set_plink_state > (state=4) => OK". So both of them are peering successfully. > > Just to confirm can you check the with "iw wlanX station dump" and take a > look on plink state. > Absolutely. The devices are successfully peered and I was wrong all the line. I just didn't wait long enough for a MPATH to be established (it actually takes about nine 9 seconds with my configuration). The problems remaining are described in my previous email to Bob Copeland. Sorry for my error.
> Did you assign the IP address to the br-lan and ping each other? If you > have two mesh gates assuming both bridge to same eth0 and connected to > same subnet, probably you need to turn STP on. Actually, I am using two distinct boards. In each one, the mesh interface is bridged with the Ethernet interface. And each board is connected through Ethernet to a PC. In this case I can avoid not network loop. I included a diagram in my answer to Bob Copeland, it explains better than words how are configured my devices. Thanks for your help. Cédric _______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
