Hello,
Not sure if anyone is still actively working on the AUTHSAE builds anymore.
So hopefully someone could point me in the right direction.
I have the latest wireless-testing - Kernel 3.19.0-r3
The latest authsae from git
Radio Atheros Communications Inc. AR9160 Wireless Network Adapter [AR9001
802.11(a)bgn] (rev 01) on both routers
I have tried the nohwcrypt=1 to see if that came back again. no change
The problem I'm seeing is the mesh peers are not encrypting traffic.
Here are some of the outputs from the various dumps.
Startup
nlcfg rates hexdump
3c 00 5a 00 78 00 b4 00 f0 00 68 01 e0 01 1c 02
----------
----------
mgtk: hexdump
6b 33 77 a5 54 3c b0 d9 4a a6 0e 96 6e 1f ee e3
----------
----------
Fixed Information Elements in this STA hexdump
01 08 8c 12 98 24 b0 48 60 6c
----------
meshd: Starting mesh with mesh id = 25mesh
----------
basic rates: hexdump
8c 98 b0
----------
joining mesh 25mesh on freq 133786976, mode 3
Unexpected error -100 (expected -107)
nlerror, cmd 68, seq 1136093589: Network is down
nlerror, cmd 11, seq 1136093594: Network is down
nlerror, cmd 10, seq 1136093595: Network is down
nlerror, cmd 11, seq 1136093596: Network is down
nlerror, cmd 10, seq 1136093597: Network is down
-----------------
Wireless Scan - from iw (version 3.17)
BSS 04:f0:21:0a:79:dd(on wlan0)
TSF: 237568059 usec (0d, 00:03:57)
freq: 5180
beacon interval: 1000 TUs
capability: (0x0000)
signal: -27.00 dBm
last seen: 785 ms ago
Information elements from Probe Response frame:
SSID:
Supported rates: 6.0* 9.0 12.0* 18.0 24.0* 36.0 48.0 54.0
DS Parameter set: channel 36
TIM: DTIM Count 0 DTIM Period 2 Bitmap Control 0x0 Bitmap[0] 0x0
HT capabilities:
Capabilities: 0x11ce
HT20/HT40
SM Power Save disabled
RX HT40 SGI
TX STBC
RX STBC 1-stream
Max AMSDU length: 3839 bytes
DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 8 usec (0x06)
HT TX/RX MCS rate indexes supported: 0-15
HT operation:
* primary channel: 36
* secondary channel offset: above
* STA channel width: any
* RIFS: 0
* HT protection: no
* non-GF present: 0
* OBSS non-GF present: 0
* dual beacon: 0
* dual CTS protection: 0
* STBC beacon: 0
* L-SIG TXOP Prot: 0
* PCO active: 0
* PCO phase: 0
MESH ID: 25mesh
MESH Configuration:
* Active Path Selection Protocol ID: 1
* Active Path Selection Metric ID: 1
* Congestion Control Mode ID: 0
* Synchronization Method ID: 1
* *Authentication Protocol ID: 0*
* Mesh Formation Info:
Number of Peerings: 1
* Mesh Capability
Accepting Additional Mesh Peerings
Forwarding
TBTT Adjusting
Wireless Scan - Iwlist
Cell 11 - Address: 04:F0:21:0A:79:DD
Channel:36
Frequency:5.18 GHz (Channel 36)
Quality=70/70 Signal level=-39 dBm
Encryption key:off
ESSID:""
Bit Rates:6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
ESSID:"25mesh"
Extra:Mesh Network Path Selection Protocol ID: 0x01
Extra:Path Selection Metric ID: 0x01
Extra:Congestion Control Mode ID: 0x00
Extra:Synchronization ID: 0x01
*Extra:Authentication ID: 0x00*
Extra:Formation Info: 0x02
Extra:Capabilities: 0x09
Mode:Unknown/bug
Extra:tsf=0000000017ae803b
Extra: Last beacon: 814ms ago
IE: Unknown: 0000
IE: Unknown: 01088C129824B048606C
IE: Unknown: 030124
IE: Unknown: 050400020000
IE: Unknown:
2D1ACE111BFFFF000000000000000000000100000000000000000000
IE: Unknown:
3D16240500000000FFFF0000000000000000000000000000
IE: Unknown: 720632356D657368
IE: Unknown: 710701010001000209
Output from iw dev mesh0 station dump.
Station 04:f0:21:0a:79:dd (on mesh0)
inactive time: 77 ms
rx bytes: 76438
rx packets: 1195
tx bytes: 262
tx packets: 3
tx retries: 0
tx failed: 0
signal: -33 [-57, -34, -40] dBm
signal avg: -33 [-56, -34, -40] dBm
Toffset: 46495765 us
tx bitrate: 6.5 MBit/s MCS 0
rx bitrate: 19.5 MBit/s MCS 2
mesh llid: 869
mesh plid: 460
mesh plink: ESTAB
mesh local PS mode: ACTIVE
mesh peer PS mode: ACTIVE
mesh non-peer PS mode: ACTIVE
authorized: yes
authenticated: yes
preamble: long
WMM/WME: yes
*MFP: no*
TDLS peer: no
authsae.conf
authsae:
{
sae:
{
debug = 480;
password = "supersecret3";
group = [19, 26, 21, 25, 20];
blacklist = 5;
thresh = 5;
lifetime = 3600;
};
meshd:
{
meshid = "25mesh";
interface = "mesh0";
band = "11a";
channel = 36;
htmode = "HT40+";
mcast-rate = 12;
};
};
Any help would be appreciated.
Fred
_______________________________________________
Devel mailing list
[email protected]
http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
