Can you confirm your mesh interface is up? Your kernel has the following patch: http://www.spinics.net/lists/linux-wireless/msg129458.html
---- Chun-Yeow On Jan 10, 2015 11:12 AM, "fred veldini via Devel" < [email protected]> wrote: Hello, Not sure if anyone is still actively working on the AUTHSAE builds anymore. So hopefully someone could point me in the right direction. I have the latest wireless-testing - Kernel 3.19.0-r3 The latest authsae from git Radio Atheros Communications Inc. AR9160 Wireless Network Adapter [AR9001 802.11(a)bgn] (rev 01) on both routers I have tried the nohwcrypt=1 to see if that came back again. no change The problem I'm seeing is the mesh peers are not encrypting traffic. Here are some of the outputs from the various dumps. Startup nlcfg rates hexdump 3c 00 5a 00 78 00 b4 00 f0 00 68 01 e0 01 1c 02 ---------- ---------- mgtk: hexdump 6b 33 77 a5 54 3c b0 d9 4a a6 0e 96 6e 1f ee e3 ---------- ---------- Fixed Information Elements in this STA hexdump 01 08 8c 12 98 24 b0 48 60 6c ---------- meshd: Starting mesh with mesh id = 25mesh ---------- basic rates: hexdump 8c 98 b0 ---------- joining mesh 25mesh on freq 133786976, mode 3 Unexpected error -100 (expected -107) nlerror, cmd 68, seq 1136093589: Network is down nlerror, cmd 11, seq 1136093594: Network is down nlerror, cmd 10, seq 1136093595: Network is down nlerror, cmd 11, seq 1136093596: Network is down nlerror, cmd 10, seq 1136093597: Network is down ----------------- Wireless Scan - from iw (version 3.17) BSS 04:f0:21:0a:79:dd(on wlan0) TSF: 237568059 usec (0d, 00:03:57) freq: 5180 beacon interval: 1000 TUs capability: (0x0000) signal: -27.00 dBm last seen: 785 ms ago Information elements from Probe Response frame: SSID: Supported rates: 6.0* 9.0 12.0* 18.0 24.0* 36.0 48.0 54.0 DS Parameter set: channel 36 TIM: DTIM Count 0 DTIM Period 2 Bitmap Control 0x0 Bitmap[0] 0x0 HT capabilities: Capabilities: 0x11ce HT20/HT40 SM Power Save disabled RX HT40 SGI TX STBC RX STBC 1-stream Max AMSDU length: 3839 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 8 usec (0x06) HT TX/RX MCS rate indexes supported: 0-15 HT operation: * primary channel: 36 * secondary channel offset: above * STA channel width: any * RIFS: 0 * HT protection: no * non-GF present: 0 * OBSS non-GF present: 0 * dual beacon: 0 * dual CTS protection: 0 * STBC beacon: 0 * L-SIG TXOP Prot: 0 * PCO active: 0 * PCO phase: 0 MESH ID: 25mesh MESH Configuration: * Active Path Selection Protocol ID: 1 * Active Path Selection Metric ID: 1 * Congestion Control Mode ID: 0 * Synchronization Method ID: 1 * *Authentication Protocol ID: 0* * Mesh Formation Info: Number of Peerings: 1 * Mesh Capability Accepting Additional Mesh Peerings Forwarding TBTT Adjusting Wireless Scan - Iwlist Cell 11 - Address: 04:F0:21:0A:79:DD Channel:36 Frequency:5.18 GHz (Channel 36) Quality=70/70 Signal level=-39 dBm Encryption key:off ESSID:"" Bit Rates:6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s 36 Mb/s; 48 Mb/s; 54 Mb/s ESSID:"25mesh" Extra:Mesh Network Path Selection Protocol ID: 0x01 Extra:Path Selection Metric ID: 0x01 Extra:Congestion Control Mode ID: 0x00 Extra:Synchronization ID: 0x01 *Extra:Authentication ID: 0x00* Extra:Formation Info: 0x02 Extra:Capabilities: 0x09 Mode:Unknown/bug Extra:tsf=0000000017ae803b Extra: Last beacon: 814ms ago IE: Unknown: 0000 IE: Unknown: 01088C129824B048606C IE: Unknown: 030124 IE: Unknown: 050400020000 IE: Unknown: 2D1ACE111BFFFF000000000000000000000100000000000000000000 IE: Unknown: 3D16240500000000FFFF0000000000000000000000000000 IE: Unknown: 720632356D657368 IE: Unknown: 710701010001000209 Output from iw dev mesh0 station dump. Station 04:f0:21:0a:79:dd (on mesh0) inactive time: 77 ms rx bytes: 76438 rx packets: 1195 tx bytes: 262 tx packets: 3 tx retries: 0 tx failed: 0 signal: -33 [-57, -34, -40] dBm signal avg: -33 [-56, -34, -40] dBm Toffset: 46495765 us tx bitrate: 6.5 MBit/s MCS 0 rx bitrate: 19.5 MBit/s MCS 2 mesh llid: 869 mesh plid: 460 mesh plink: ESTAB mesh local PS mode: ACTIVE mesh peer PS mode: ACTIVE mesh non-peer PS mode: ACTIVE authorized: yes authenticated: yes preamble: long WMM/WME: yes *MFP: no* TDLS peer: no authsae.conf authsae: { sae: { debug = 480; password = "supersecret3"; group = [19, 26, 21, 25, 20]; blacklist = 5; thresh = 5; lifetime = 3600; }; meshd: { meshid = "25mesh"; interface = "mesh0"; band = "11a"; channel = 36; htmode = "HT40+"; mcast-rate = 12; }; }; Any help would be appreciated. Fred _______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
_______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
