Hey, this are good news... I'll give it a try... ;) Edson
>-----Original Message----- >From: [EMAIL PROTECTED] [mailto:devel- >[EMAIL PROTECTED] On Behalf Of Anatoly Pidruchny >Sent: quinta-feira, 29 de maio de 2008 09:35 >To: Juha Heinanen; devel@lists.openser.org >Subject: Re: [OpenSER-Devel] changing debug level on the fly > >Juha, > >you can also change the debug level temporarily per process for a script >section using the script function setdebug. Below is some information >from the ChangeLog for 1.3.x release. This function is still not >documented in the core cookbook. > >2007-07-19 08:23 Bogdan-Andrei Iancu, <bogdan at voice-system dot ro> > > * [r2478] action.c, cfg.lex, cfg.y, dprint.c, dprint.h, route.c, > route_struct.c, route_struct.h: > - new core script function - setdebug([leve]) - it can be used to > change the debug level (per process) for a script section. > >-- >Anatoly. >> Edson writes: >> >> > It would be even better if this control could be done not only through >MI >> > commands, but also through script commands/variable. It would permit >> > increase and decrease debug level based on script logic given a more >> > granular control over debug info. >> >> that should be possible if debug variable would be mapped to a shared >> memory variable that could then be set using cfgutils functions. >> >> -- juha >> >> _______________________________________________ >> Devel mailing list >> Devel@lists.openser.org >> http://lists.openser.org/cgi-bin/mailman/listinfo/devel >> >> > > >_______________________________________________ >Devel mailing list >Devel@lists.openser.org >http://lists.openser.org/cgi-bin/mailman/listinfo/devel _______________________________________________ Devel mailing list Devel@lists.openser.org http://lists.openser.org/cgi-bin/mailman/listinfo/devel
